Installation And Commissioning - Fiap AIR ACTIVE OxyFlow Notice D'emploi

GB POND AERATION
All work with this device may only be carried out in accordance with these instructions.
The combination of water and electricity can lead to serious danger to life and limb if it is
not connected properly or handled improperly.
Only operate the device when nobody is in the water!
Before reaching into the water, always unplug all devices in the water. Compare the
electrical data of the power supply with the type plate on the packaging or on the de-
vice. Make sure that the device is protected by a residual current device with a rated
residual current of maximum 30 mA. Only operate the device from a properly installed
socket. Keep the power plug and all connection points dry! Lay the connection cable so
that it is protected to prevent damage. Only use cables, installations, adapters, extension
or connection cables with protective contact that are approved for outdoor use. Do not
carry or pull the device by the connecting cable! The device must not be operated if the
cable or housing is defective! If the power cord of the device is damaged, the device must
be disposed of; it is no longer possible to replace the power cord. If the cable is damaged,
the device must be disposed of. Electrical installations on garden ponds must comply with
international and national installation regulations. Never open the housing of the device
or its associated parts unless this is expressly stated in the instructions for use. Never
make technical changes to the device, this leads to the immediate expiry of all
warranty and guarantee claims. Use only original spare parts and accessories. Have
repairs carried out only by authorized customer service centers. Never operate the
device without water flowing through it! Never pump liquids other than water!
For your own safety, contact a qualified electrician if you have any questions or problems!
Caution, LED light: do not look into the LED light beam! Do not look at it directly
or with optical instruments

INSTALLATION AND COMMISSIONING

The device is delivered as a complete set with power supply unit and all necessary
9
accessories. The float is delivered pre-assembled. If the float is not installed, follow the
installation instructions below: