Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Using The Quick-Disconnect Cable Assemblies
Connect either of the two output cable assemblies to the solar battery maintainer. Do
not place on wet ground, anywhere it could be accidently stepped on or in a place or
position where it could fall while being used. Never use the output cables together or for
other applications.
50 Amp Battery Clip Cable Assembly
1.
Connect the end of the solar battery maintainer output cable to the end of the 50
amp battery clips cable.
2.
Follow the steps in sections 6 and 7 to connect the output clips to the battery.
3.
After a good electrical connection is made to the battery, place the solar panel in the
sun, per the instructions in step 4 of the maintaining section.
12V Accessory Plug Cable Assembly
Maintain your battery without lifting the hood.
1.
Connect the end of the 12V accessory plug cable to the solar battery maintainer.
2.
Insert the 12V accessory plug into the 12V accessory outlet.
3.
Route the power cord from the solar battery maintainer through the vehicle's open window.
4.
Place the solar panel in the sun, per the instructions in step 4 of the maintaining section.
Maintaining a Battery
If you are maintaining a fully charged battery, you will be properly utilizing the solar
battery maintainer. The Schumacher SP-200 is a battery maintainer that maintains
12 volt batteries, keeping them at full charge. However, if you were to use this solar
battery maintainer to charge a battery, you may lose some of the battery's capacity. This
would cause the battery to be unable to hold a charge and become useless. Therefore,
we do not recommend charging any battery with this unit.
NOTE: The maintain mode technology utilized in Schumacher maintainers allows you
to safely maintain a healthy battery for extended periods of time. However, problems
with the battery, electrical problems in the vehicle, improper connections or other
unanticipated conditions could cause excessive current draws. As such, occasionally
monitoring your battery and the maintaining process is recommended.
11.
MAINTENANCE INSTRUCTIONS
11.1
After use and before performing maintenance, unplug and disconnect the solar battery
maintainer (see sections 6, 7 and 8).
11.2
Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery clips,
cords and the solar panel.
11.3
The solar panel uses a glass substrate; please handle with care.
11.4
Always keep the glass surface clean using a soft cloth in order to ensure its maximum output.
11.5
Ensure that all of the solar battery maintainer components are in place and in good
working condition, for example, the plastic boots on the battery clips.
11.6
Servicing does not require opening the unit, as there are no user-serviceable parts.
11.7
All other servicing should be performed by qualified service personnel.
12.
MOVING AND STORAGE INSTRUCTIONS
12.1
Store the solar battery maintainer unplugged, in an upright position.
12.2
Store inside, in a cool, dry place.
12.3
Do not store the clips clipped together, on or around metal, or clipped to cables.
12.4
If the solar battery maintainer is moved around the shop or transported to another
location, take care to avoid/prevent damage to the cords, clips and solar battery
maintainer. Failure to do so could result in personal injury or property damage.
6
•
•
Publicité
Table des Matières
