Whispbar K328W Instructions De Montage page 6

EN
Fitting Kit
K328W
Use two M5 x 12 mm self tapping screws to
secure the assembly onto the leg.
Do not over tighten.
Repeat for all legs.
Slide clamp back towards centre of
crossbar.
Insert M6 x 70 mm capscrew through
square brass washer and rail mount
assembly.
The M6 x 70mm capscrew inserts into
brass threaded tube in rear clamp.
NOTE: Lift rubber protector tab to ensure
that capscrew aligns directly into brass
tube before starting to tighten.
Take care not to cross-thread the
capscrew.
6