Agri-Fab 45-02922 Notice D'utilisation page 5

7. At this time tighten all bolts starting with the bolts in
figure 2, then the bolts in figure 3.
8. Install the drain in the rear of the tank as shown in figure
4. Place a 3/4" garden hose gasket onto the drain body
and insert the drain body out through the hole in rear of
the tank. Outside the tank, assemble the nylon washer,
then the nylon nut onto the drain body. Tighten the nut
securely enough to prevent leaking, being careful not
to damage the plastic parts. Place the O-ring inside the
nylon cap and screw the cap onto the end of the drain
body. See figure 4.
FIGure 4
9. Assemble the boom mount bracket to the rear of the
hitch tubes using two 5/16" x 2" hex bolts and 5/16"
nylock nuts. See figure 5.
BOOM MOUNT
BRACKET
5/16" NYLOCK NUT
5/16" x 2"
HEX BOLT
FIGure 5
NYLON
WASHER
NYLON NUT
O-RING
NYLON CAP
HOSE
GASKET
DRAIN BODY
enGlIsH
10. Assemble the boom bars to the boom mount bracket
using two 5/16" x 1-1/4" carriage bolts, tooth lock washers
(between the bar and bracket), 5/16" flat washers and
knobs. The boom connecting hose should extend upward.
See figure 6.
noTe: Make sure the nozzle openings face straight
down when the boom bars are in the horizontal operating
position.
BOOM CONNECTING HOSE
5/16" WASHER
KNOB
BOOM BAR
CARRIAGE BOLT
5/16" x 1-1/4"
FIGure 6
11. Assemble the large and small spray gun clips to the
side of the tank using two #10 x 1/2" screws and #10
lock washers. See figure 7.
#10 x 1/2"
SCREW
#10 LOCK
WASHER
FIGure 7
5
WASHER
(TOOTH LOCK)
SPRAY GUN
CLIP (LARGE)
SPRAY GUN
CLIP (SMALL)
VIeweD From rear