Troubleshooting; Product Specifications; Adaptor Specifications - Bigben BTA01 Mode D'emploi

Diffuseur d'arôme bluetooth
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1

Troubleshooting

If the unit stops working, please refer to the sheet below.
Units fails to turn on
Turns off suddenly during operation
No mist or abnormal mist
Water leakage from product

Product Specifications

Unit size: 178*178*97mm
Unit weight: Approx. 413g
Power: Input/Output AC100-240V 50/60HZ / DC
24V 500MA
Adaptor cable length: Approx. 150cm
Electrical consumption: Approx. 7W
Timer: ON/1H/3H/6H/Customise
Mist mode: High mist mode/ Low mist mode/
Intermittent mist mode
Water capacity: 400ML
Material: PP / ABS
Ultrasonic vibration: 2.4MHz
Bluetooth music pairing name: Aromamusic
APP: Pairing name "Aroma 31"
Remark: The maximum connection distance is around 10 meters. Please place your Bluetooth
speaker as close as possible to this device to avoid connection getting disturbed.
● Is there enough water in the tank?
- If not, add water to the tank.
● Is the power cord connected properly?
- If not, disconnect cords, check them and re-
connect carefully.
● Does the water amount exceed the MAX line?
- If so, reduce the water amount and ensure it is
below the MAX line.
● Does the water amount exceed the MAX line?
- If so, reduce the water amount and ensure it is
below MAX line.
● Not enough water or too much water?
- Add water to the tank, but do not fill over the
400 ml MAX line.
● Is there dirt on the ultrasonic atomiser?
- Please refer to maintenance instructions to
clean the unit.
● Is there too much dirt on the air intake?
- Please use the brush to clean the air intake.
● Low temperature or high humidity?
- Under these conditions, the mist may
condense quickly into water droplets. Please
wipe them up.

Adaptor Specifications

Input: 100-240V-50/60Hz 0.35A
Output: 24.0V-0.5A
Cable length: Approx. 1.5cm
- EN 9 -

Publicité

Table des Matières
loading

Table des Matières