cecotec FIT EXTREME 20 Guide D'utilisation page 9

ENGLISH
ASSEMBLY
Step 1: Stabilizers:
Will rear foot tube out to the rear portion of the frame strip holes, in bolt are sequentially
sheathed flat pad with a diameter of 10, an elastic pad with a diameter of 10 and then
set on the cap nut type, we have with the special open spanner locking (the front leg
pipe installation method).
Note: after the installation of the product may occur after the foot of the foot of the three
foot, this time can be adjusted to the foot of the black pin set to balance the product
level.
Step 2:
Remove the foot pedal, will find the foot is marked with "L", "R". Turn the "R" foot clockwise,
and then use a dedicated open-end wrench. Turn "L" foot counterclockwise, until the
pedal is fixed, and then locked with a special opening.
Note: the crank is also marked with "L" and "R" with the foot pedal, if it is reversed, it may
cause a crank to damage the product. And must be locked, or with a long time after the
foot may fall off.
16
Step 3:
Opened the ball head of the pull pin, the cushion fixing seat upwards until the appropriate
height, loosing the ball head pull pin, the pin penetrates into the cushion fixing seat hole
after locking ball head pull pin can be (loosen the lock bolt, can move the seat cushion,
adjust to the comfortable position, the lock bolt can be).
Step 4:
The armrest fixing seat upwards, and then remove the locking bolt, penetrates into the
tight set screw thread lock, adjust the armrest fixing seat height is locked the bolt can
be locked.
ENGLISH
17