Epson ELPSC21 Guide D'utilisation page 5

4
Install the screen.
* The screen is wrapped around a core for transportation. Remove the core and discard it.
Hook the screen on either side of two
1
shafts and spread the screen. The white
surface should be in front.
* The white part of the screen should be completely dried before shipping. When you use the screen for the
first time, you may notice a slight chemical odor. This odor will disappear while you use the screen. If the
odor is too strong, open up a window to ventilate the room and allow it to dry for a few days.
5
Adjust the height of the screen.
Pull up the adjuster lever and slide the extension
1
pole up and down to adjust the height.
* Raise the extension pole slowly when adjusting the height.
Be careful not to pull it too far or it may come out.
Storing
Remove the screen first. If the stand is folded before removing the screen, it could fall and cause an injury.
1
Remove the screen.
Pull up the adjuster lever and lower the extension pole. Push down the adjuster lever after
1
lowering the extension pole.
Remove the shafts in reverse of the way they were installed.
2
2
Store the screen.
Roll up the screen without wrinkling it and
store it in the storage case.
3
Store the stand.
Pull the shafts straight out from the holder. Hold the stand securely with one
1
hand.
Remove the stabilizer from the tripod. Step on the stabilizer and lean the stand
2
backward so that the stabilizer separates easily.
Pull up the tripod lever and fold the tripod.
3
Store the stand first, then the shafts, and stabilizer in that order. Make
4
sure the hooks at the tips of the shafts are facing outward.
* Store the screen, stand, and shafts correctly.
If it is not done correctly, the screen could get dirty or damaged.
Hook the screen on the other two shafts.
2
Push the hooks slightly into the shafts to put
them into the holes on the screen easily.
Push down the adjuster lever to secure
2
the extension pole.