Marmitek XCAM2 Mode D'emploi page 4

4. Select the right Channel
Look for the corresponding channel with your camera by switching the channel
slide switch at the bottom of the receiver [I] (camera channel may be changed by
removing the rubber cover on the frontside of the camerabase[B]). Receiver and
camera should be set on the same channel.
5. Position the GigaVideo Receiver in a convenient location and orient the
antenna [D] so that the indented side points in the direction of the room where
you set up the XCAM camera
3. FINE TUNING YOUR MARMITEK XCAM2 SET:
The wireless GigaVideo usually works best with the indented faces of the
antennas [A+D] on the Transmitter and Receiver unit facing each other (i.e. in
Line of Sight. Sometimes however reflections and other effects in the home may
affect the signal so that some adjustment of either Transmitter or Receiver
antenna may be necessary to get the best signal.
If you are not getting any signal at all:
Check that the receiver is connected to mains and that the Power-switch is in the
ON position. Check that the Channel slide switch [B+I] on both units is set at the
same number.
If the signal is poor, or there is interference:
Try changing the channel on both units. Do this by adjusting the Channel slide
swich [I] on the bottom of the GigaVideo receiver unit to any position from A-D.
The camera channel may be changed by removing the rubber cover on the
frontside of the camerabase [B] and change the slide switch position. Receiver
and camera should be set on the same channel.
Ó
Copyright Marmitek X-10 .
The right is reserved to make technical modifications
4