Télécharger Imprimer la page

Marmitek XCAM2 Mode D'emploi page 3

Publicité

Les langues disponibles

Les langues disponibles

READ THIS FIRST!
Caution: to reduce risk of electric shock, do not disassemble any part of the
videosender system. No user-serviceable parts are inside. If you spill liquid on it,
disconnect the unit from the AC outlet to prevent possible fire or shock hazard
and consult authorized service personnel.
Powerline operated equipment or accessories connected to the unit should bear
the CE certification mark and should not be modified in any way that might defeat
the safety features.
Warning: to prevent electric shock hazard, do not expose any part of the power
supplies to rain or moisture. Do not use near a bath tub, swimmingpool, etc.
APPLICATIONS:
Using the Marmitek wireless XCAM2 provides convenience and security in many
ways:
Watch your frontdoor on any TV in Your home without running cables.
·
Watch your baby's rooom on any TV anywhere in your house.
·
1. HOOKING UP THE MARMITEK XCAM 2 CAMERA:
1.
Attach the camera to a wall
2.
The camera can be used outdoors, if mounted on a sheltered location.
3.
Avoid direct liquid entry.
4.
Apply for outdoor use the plastic lens cover supplied.
5.
If you install the camera outdoors, make a small hole in your exterior
wall or doorframe and pass the low voltage power jack [C] through it.
6.
Take the smaller of the two powersupplies (model "transmitter").
7.
Plug the power supply jack into the socket on the adapter cable from
the camera.
8.
Connect the powersupply with mains.
9.
Adjust the antenna [A] if necessary to aim it in the direction of the TV or
monitor that you will view the camera on.
Only use the supplied mains adaptor!
2. HOOKING UP THE MARMITEK XCAM2 RECEIVER:
1. Connect a set of Audio/Video cables to the LINE OUT jacks [H+G] of your
GigaVideo Receiver. Connect the other end to your TV.
2. Plug the supplied mains adaptor, labelled Receiver 500mA, into a 230Volt -
50Hz wall outlet and connect the jack [E] to the 12V jack at the backside of the
receiver.
Only use the supplied mains adaptor!
3. Switch the Power switch [E] to the ON position.
OWNER'S MANUAL
3

Publicité

loading

Ce manuel est également adapté pour:

Wireless xcam2