Unit Operation Via A Web Browser - Komfovent C6.1 Manuel D'installation Et D'utilisation

2.2. Unit operation via a web browser

Not only the control panel, but also a computer can be used to monitor the operation of unit and its components,
as well as changing the settings and activating additional functions. You only have to connect the unit separate
with the network cable, to a computer, local network or Internet.
Procedure for the direct connection to the computer:
1. Plug one end of the cable into the network socket in the controller (see Fig. 1.3 a.), and the other into the
computer.
2. On the computer, in the manual setting box of the computer's network card, enter the IP address, e.g.,
192.168.0.200 and a subnet mask: 255.255.0.0.
3. Run the Internet browser on the computer and disable the use of all Proxy servers in the settings.
4. In the web browser address bar, enter the default IP address of the air handling unit, 192.168.0.60; but this
can be changed at any time in the panel (in the Advanced Settings menu), and on-line via a web browser
(see the login interface settings).
Tip: Before using, it is recommended to update your web browser to the newest version.
5. If the connection was successful, a window will open where you will have to enter a user name and login
password:
Tip: The user's login name is "user". The initial password is also "user", but the user can later change this to
any other password (see the user interface settings).
UAB AMALVA we reserve the right to make changes without prior notice
C6-17-01
Should you forget a changed password, it can be reset to the initial
"user". To do this, you must restore the factory settings for the air han-
dling unit.
23