OPERATING INSTRUCTIONS
TOUCH controls
SWITCHING ON
To use Eve, you must first connect the
power cord to the electrical socket
using the plug supplied.
Two keys on the body of the Eve radia-
tor, acting as indicator LEDs as well as
touch controls, show when the device
is switched on or off.
Only when first switched on, Eve
automatically performs the set-up and
the two LEDs emit WHITE light for 10
seconds. Eve then goes into Stand-by
mode and the user can select the desi-
red operating mode.
When switched on subsequently,
Eve will already be set up and the two
LEDs will emit WHITE light only for 2
seconds. In this case too, Eve then goes
into Stand-by mode and the user can
select the desired operating mode.
Stand-by mode is indicated when the
ON/OFF control
,lights up, turning
RED, and the MODE control
trol switches off, followed by a beep.
OPERATING MODE
Make sure that the device is in Stand-by
mode. The operating modes can be se-
lected using the two keys on the body
of Eve that act as touch controls, as well
cod. MAN#EVE - Luglio/July 2019
Key/Led ON/OFF
Key/Led MODE
Mains
Connection Plug
, con-
as indicator LEDs.
To turn on the desired control, simply
lightly touch the icon corresponding to
that control with your finger.
Do not press.
• LIGHTING Mode
Lighting provides for a dimmable light
emitted from the lower vent of the
body. It is turned on using the following
procedure:
Touch the ON/OFF control
seconds: : the LED will remain WHITE
but the device will emit a beep and the
light will come on.
Touch the ON/OFF control
3 seconds: the LED will remain WHITE
but the device will emit another beep
and the light will go off.
To regulate the brightness of the dim-
mable light, keep pressing the MODE
control
for at least 6 seconds until
the light begins to vary its brightness.
The light will alternate between dim-
med and bright phases until the control
is released at the desired level.
• HEATING Mode
Heating involves emission of a heat
through the openings in the structure,
adjusted according to two different
power levels. It is turned on using the
following procedure:
• Touch the MODE control
second: the LED turns ORANGE and the
device emits a high power flow of hot
air (about 800W);
• Touch the MODE control
second: the LED turns GREEN and the
device emits a low power flow of hot
air (about 400W);
• Touch the MODE control
second: the LED turns ORANGE again.
If you continue to click on the MODE
for 3
again for
for 1
for 1
for 1
13