TUBES EVE Manuel D'utilisation page 14

control, the device will alternate betwe-
en the two heating modes.
Heating is always accompanied by Eve's
ventilation. When the heating comes
on, you have to wait a few minutes
before Eve effectively begins to heat to
allow the device to detect the indoor
temperature. This "adjustment venti-
lation" phase varies according to the
temperature detected and may last a
few minutes.
To exit each of these modes, you only
have to switch the device back to
stand-by mode by touching the ON/OFF
control . Heating is immediately tur-
ned off. However, ventilation continues
for a time varying from 2 to 20 minutes,
according to the temperature detected
internally, in order to cool the tempe-
rature inside the device. After this time
has ended, the device switches off.
• 2 hr BOOST mode
The 2 hr boost mode turns on the hea-
ting of the device at MAXIMUM power
(32°C) for a total of two hours from
when the boost mode starts. When this
time has ended, the device will auto-
matically return to the previous heating
mode.
It is turned on using the following pro-
cedure:
• Touch the MODE control
conds, after which the device will emit
a beep indicating the correct turning on
of the Boost mode. The LED turns DARK
RED. This function can be turned on
during any of the heating modes descri-
bed above.
There are two ways to exit this mode
before the two hours are up:
• Return to the heating mode set befo-
re Boost by touching the MODE control
again for 4 seconds. In this case too,
a beep will be heard indicating that
it has correctly returned to the mode
previously set;
14
• Switch the device back to stand-by
mode by touching the ON/OFF control
.
Wi-Fi and PLUG&PLAY APP
CONFIGURATION
You can control the temperature of
your home when you are away from
it, thanks to the TUBES Plug&Play app.
The TUBES Plug&Play app allows you to
turn your Eve on or off, raise or lower,
and programme its temperature direct-
ly from your smartphone, at any time
and wherever you are.
Since it has its own Wi-Fi network
known as "TUBES EVE - XXXXXXXXXXXX"
(where the Xs correspond to the MAC
address of the Wi-Fi module inside the
device). This network allows it to con-
nect to the home Wi-Fi network and be
programmed remotely.
How to set up the Wi-Fi network
When first switched on, the device au-
tomatically performs the Wi-Fi network
set-up.
The two LEDs on the body of the device
emit a WHITE light for 10 seconds until
set-up is complete. Eve then goes into
stand-by mode and the user can select
the desired operating mode
for 4 se-
• If, for any reason, the set-up is not
successful, the device will automatically
repeat this procedure the next time the
device is switched on.
• When it is first switched on, Eve's de-
fault settings are as follows:
• Temperature set: 32°C
• Light: on at 45% intensity
• Open window detection: off
• Programme times:
MON-FRI
SAT-SUN
06:00-09:00;
11:00-14:00;
07:00-24:00;
17:00-24:00;
cod. MAN#EVE - Luglio/July 2019