Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONFIGURE
The BSWM has three settings that can be configured:
1.
The sensitivity of the vibration detection
2.
The voltage
3.
The time that the BSWM remains switched on after
detecting the last vibration.
Once the configuration connection of the BSWM (CONFIG
connection) is connected to the positive (+) terminal of the
primary battery for 4 seconds, the LED will blink once. When
this happens, the connection must be broken.
This same connection must briefly be made again to set the
correct configuration – the LED will light up as feedback. This
means that configuration #1 has been selected. If the user
briefly makes the connection again, configuration #2 will have
been selected, etc.
When there has been no connection between the configura-
tion connection and the positive terminal (+) of the primary
battery for 4 seconds, the LED will again display the set
position. (Example: Configuration #4 has been set by the user,
the LED will flash 4 times.)
TECHNICAL DETAILS
Supply voltage
Start-Assist voltage
Switchable current
Connections
Cable diameter (minimum)
Weight
Dimensions (L x W x H)
Current take-up
Off with regard to minimum voltage (after 0.25 s)
Off with regard to maximum voltage (after 0.25 s)
CONFIGURATION TABLE
#
Sensitivity
1*
Combination of positions 3 and 9
2
Combination of positions 3 and 12
3
voltage-dependent control
4
5
1 (most sensitive)
6
7
8
2
9
10
11
3
12
13
14
4
15
16
5 (least sensitive)
17
8 – 35 V DC
8 – 35 V DC
160 A
Bolts
M8
Faston
6.3 mm
50 mm2
470 g
108 mm x 72 mm x 58 mm
Relay closed
±340 mA @ 13.5 V
±170 mA @ 27.0 V
Relay open
±1.8 mA @ 13.5 V
±2.0 mA @ 27.0 V
12 V system
<11.6 V (reset when >11.8 V)
24 V system
<23.2 V (reset when >23.6 V)
12 V system
>17.0 V (reset when <16.8 V)
24 V system
>34.0 V (reset when <33.6 V)
Time (sec)
1
5
30
1
5
30
5
30
60
5
30
60
30
60
Publicité
Table des Matières
