How To Use - Rotel U685CH1 Mode D'emploi

 HOW TO USE
o When you use your steam mop for the first time or if you have not used it in a while,
it may take one or two minutes for the water travelling through the pump into the
boiler to create Steam. Start it by press the switch and tilt the main body. If you have
waited for a few minutes but there is still no steam, please refer to the
aftermentioned <<Failure Recovery>>.
o ▲ Important: Your steam mop needs water to make steam! Never use your steam
mop without water in the tank. If your steam mop stops steaming, it could be out of
water. Unplug the power cord from the electrical outlet and refill the water tank at
anytime.
o ▲ Attention: Sweep or vacuum your floors prior to cleaning with steam mop.
o 1. Twist the cord holder downwards to quickly unwrap the power cord completely.
(fig. 1)
o 2. Plug into the electrical outlet. The indicator light will illuminate in red. If the
indicator light does not illuminate, please refer to the aftermentioned <<Failure
Recovery>>. (fig. 2)
o 3. Tilt the steam mop and press the switch button to turn on, while the indicator light
will turn blue. Wait 30 seconds for steaming. (fig. 3, fig. 4)
o 4. During the cleaning process, the steam mop automaticly produces high
temperature steam for cleaning and sterilizing that save energy. This product is set
up with automatically stop when it's upright to prevent excess steaming caused by
human negligence. When you tilt the steam mop it will restart steaming, or if the
indicator light turned red you can press the switch button to turn it on again.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use