Notes; How To Reset Your Unit; Cleaning The Unit; Fcc Warning - Kenwood KOS-A200 Mode D'emploi

Notes

• No USB device comes with this unit. You need to
purchase a commercially available USB device. For
the types of available USB devices, refer to <About
USB device> (page 5).
• If you experience problems during installation,
consult your Kenwood dealer.
• When you purchase optional accessories, check
with your Kenwood dealer to make sure that they
work with your model and in your area.
• The characters which can be displayed by this
unit are A-Z 0-9 @ " ' ` % & * + – = , . / \ < > [ ] ( ) : ;
^ - { } | ~ ! ? # .
• The illustrations of the display and the panel
appearing in this manual are examples used to
explain more clearly how the controls are used.
Therefore, what appears on the display in the
illustrations may differ from what appears on the
display on the actual equipment, and some of the
illustrations on the display may be inapplicable.
• The reception of tuner may be reduced a little if
the KOS-A200 is used.
• If your car stereo does not have muting, there
may be some noise before power switch of
control unit is ON and OFF. If this happens, turn
down the volume of the car stereo.

How to reset your unit

• If the unit fails to operate properly, take off power
supply cord plug from the unit. After waiting
several seconds, connect power supply cord plug
again. The unit returns to factory settings.

Cleaning the Unit

If the faceplate of this unit is stained, wipe it with a
dry soft cloth such as a silicon cloth.
4
|
English

FCC WARNING

This equipment may generate or use radio
frequency energy. Changes or modifications to
this equipment may cause harmful interference
unless the modifications are expressly approved
in the instruction manual. The user could lose
the authority to operate this equipment if an
unauthorized change or modification is made.
NOTE
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment may cause harmful
interference to radio communications, if it is
not installed and used in accordance with the
instructions. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.