Specifications; Standard Accessories - Hitachi C 10FCH2 Mode D'emploi

English

SPECIFICATIONS

I
tem Model
Motor Type
Power source
Voltage (Volts)
Full-load current (Amp)
Laser Marker Maximum output
(Only Model Wave length
C10FCH2) Laser medium
Applicable
saw blade
No load speed
Max.
sawing Miter
dimension
Bevel
Compound
Miter sawing range
Bevel sawing range
Compound sawing range
Net weight
Cord
ACCESSORIES
WARNING:
Accessories for this power tool are mentioned in this Instruction Manual.
The use of any other attachment or accessory can be dangerous and could cause injury or mechanical damage.

STANDARD ACCESSORIES

1 10 in. (255mm) TCT Saw
blade (1 piece) (For wood)
(No. of teeth 24
Code No. 318963)
8 M6 Nylon nut
(1 piece)
6
C 10FCH2 / C 10FCE2
Series commutator motor
Single-phase AC 60Hz
120
15
<1mW CLASS II Laser Product
400 – 700 nm
Laser Diode
Outside Dia. 10 in. (255mm)
Hole Dia. 5/8 in. (15.9mm)
5000/min
He
ad Turntable
0
0 Left 45°
Left 45°
Left 45° Left 45°
Left 0° – 52° Right 0° – 52°
Left 0° – 45°
Left (Bevel) 0° – 45°, Left and Right (Miter) 0° – 45°
26.5 lbs. (12 kg) / 26.3 lbs. (11.9 kg)
2 Conductor type cable 6ft. (1.8m)
2 Dust bag (1 piece)
For how to use, refer to
page 13.
3 Vise Assembly w/knob bolt
(1 piece)
For how to use, refer to
page 10.
9 Plate (A)
(1 piece)
Fig. 3
Max. sawing dimension
0 Max. Height
Max. Width
or
Max. Height
Max. Width
Max. Height
Max. Width
0 Max. Height
Max. Width
Max. Height
Max. Width
4 10mm BOX wrench
(1 piece)
5 4mm Hex. bar wrench
(Only C10FCH2)
For how to use, refer to
page 10.
0 Holder (B)
(1 piece)
in.
2-5/16 (59mm)
5-21/32 in. (144mm)
in.
3-1/2 (89mm)
3-31/32 in. (101mm)
in.
2-5/16 (59mm)
4 in. (102mm)
in.
1-5/8 (41mm)
in.
5-21/32 (144mm)
1-5/8 in. (41mm)
4 in. (102mm)
6 Sub fence
(1 piece)
7 Flat screw
(1 piece)
A Side handle
(1 piece)