The workplace
Choose a suitable place for the machine. This shall
conform to applicable provisions for job security and
have a suitable power and compressed air supply.
The ground must be firm and level and can support the
weight of the machine.
Provide at least 1m free space around the machine.
Attach the machine through the 4-prepared holes on
the machine feet to sub-floor.
Electrical connection
When working on an not grounded machine:
Serious injury due to electric shock in the event of a malfunction possible!
Therefore the following applies: Machine must be operated at a grounded power socket.
The electrical connection of the machine is ready for operation on a grounded outlet!
If a plug is supplied, this must only be connected to a properly fitted and grounded electrical
outlet! The plug (if supplied) must not be changed. If this does not fit or is defective, only a
qualified electrical engineer may modify or replace the plug!
The grounding conductor is green-yellow! In the event of repair or replacement of the grounding
conductor must not be connected to an under voltage can! Check with a qualified electrician or
service that the grounding instructions are understood and the machine is grounded!
A damaged cable must be replaced immediately!
Compressed air connection
Connect the machine with the compressed air connection (24) to your pneumatic device. Please
note the ZI-RMM94H must only be connected to a compressed air supply with 8-10 bar.
Operating test
Check the function of the pedals as well as the compressed air supply. In case of malfunction the
respective connections shall be checked again!
15
OPERATING
To avoid damage, use the supplied tire lever for mounting, or dismounting tires.
The area between the tire and rim, in which rests the bead breaker should always be coated
for ease of disassembly and protect the rim with lubricant or soapy water.
Take care when mounting the tire on any given course directions on the tire sidewall.
Tire and rim must fit the dimensions forth to each other.
Check the tire always for damage (deformation, surface damage, extreme wear and tear)
before removing the tire.
Always bear in mind any special assembly / disassembly instructions from the tire
manufacturer.
If you inflate the tire, make sure that the pressure rise is normal and pay attention to the tire
bead.
ZIPPER MASCHINEN GmbH
ZI-RMM94H24
www.Zipper-Maschinen.at
W A R N I N G
N O T I C E
ASSEMBLY
24