Adjusting The Sensitivity Of The Movement Detector - Spyball 6527 Notice De Montage

6. Adjusting the sensitivity of the movement detector

The movement sensor of the 6527 has 8 different levels of sensitivity, which can be set via the radio transmitter.
These 8 levels fall into 2 main categories: HIGH sensitivity (basically intended for motorcycles), LOW sensitivity (basically
intended for scooters); within each group 4 different settings are possible.
To adjust sensitivity, operate as follows:
Press push-button n. 1 of a transmitter to arm the unit
-
After the turn indicators have extinguished, turn the ignition key ON and wait about 15 secs 4 The LED extinguishes for a
-
couple of seconds
During this time period press push-button n. 1 of the transmitter to select the HIGH sensitivity category, or push-button n.
-
2 to select the LOW sensitivity category 4 The unit will bleep once if it was previously set to low sensitivity or three times
if it was set to high sensitivity (Remark: this is meant to give you the opportunity to check how the system was set)
At this stage the LED will start cycling through 4 different flashing frequencies: THE QUICKER THE FLASHING, THE
HIGHER THE SENSITIVITY. (Remark: the starting point is the sensitivity level the system was previously set to). Turn the
ignition OFF when you come to the sensitivity level you wish to select 4 The unit will bleep once and the turn indicators flash to
confirm the success of the operation.
Manuale di installazione AB6527EUSBB - inglese/francese/olandese - Rev. 00 - 06/04 - Pagina 5 di 15
Codice 06DE1824B