Transport - Pubert Devor X 40 Notice D'utilisation

1 motor off, spark plug cable disconnected, fuel supply shut
2
The shredder must only be transported in a trailer.
Use appropriate loading ramps.
Tie the shredder down correctly using straps.
To unload, follow these instructions in reverse.
(to be done by your approved repairer) (To wear gloves)
- Disconnect the spark plug cable
- Open the obstruction clearance hatch (see VI –e)
- Remove the feeding chute (see V 2g)
- Using a 4 mm allen key and a 10 mm open ended spanner, unscrew the 3
screws (1) and nuts (2) holding the 2 blades in place (3).
- To always replace screws and nuts during replacement or sharpening (see
diagram 1) for knife. (caution only knives as well as fastening screws spe-
cifically designed for your crusher must be used.)
- To reassemble knives (Torque 9.8N.m)
VII / TransPorT
do not lift the shredder
VIII / To sHarPen or cHange KnIVes
2
3
1
13 - EN
Tie-down points
for trailer transport
diagram 1
To respect wedge angles
If side mini C less than 36 mm, it is
compulsory to replace.
Risk of your machine deteriorating.
(Rotor imbalance)