Display And Buttons - Audio Pro LIVING LV1 Manuel D'utilisation

JOIN LV1 WITH EXISTING AUDIO PRO NETWORK
+
Any LV speaaker with
TX100 transmitter
PLAY WIRELESS FROM OTHER SOUND SOURCE
The TX100 transmitter has a sound input on its side to connect to a 3.5mm stereo cable. You can
connect any device with sound output/headphones to the transmitter. Computer, mp3-player, iPod/
iPhone/iPad dock, cellphone, stereo/receiver, cd-player, radio, etc. TX100 contains an advanced
Burr-Brown A/D converter for best sound reproduction. The transmitter TX100 must be powered by
an USB power adaptor if connected by cable (sold separately).
Connect all devices with sound output/
headphones. Examples:
iPod/iPhone/iPad dock
Cellphone
CD-player
Network player
Stereo/receiver
TV

DISPLAY AND BUTTONS

TABLE STAND
If you already own other LV speakers and a TX100 transmitter,
let LV1 join your existing network like this:
1. Place LV1 within range of transmitter, connect to power.
2. Set to same channel (House Code) as transmitter.
3. Done! LV1 is now part of your wireless network.
Under grille you will find display, IR receiver for remote, LED
status indicator, volume, setting channel (House Code), and
setting volume zone (Zone).
1. VOL; volume, + to increase; – to decrease.
2. HOUSE CODE: one push displays chosen channel (1, 2,
3).
Further pushes changes channel 1>2>3 and back to 1.
3. ZONE: one push displays chosen volume zone (A, B, C).
Further pushes changes channel A>B>C and back to A.
Note: Display only shows information for 3 seconds after setting (on
buttons or with remote). Then it is turned off.
To avoid early reflections in flat surfaces, place LV1 on the
enclosed table stand. The angle of the stand reduces
reflections. Use if placed on large flat surface, like table,
sideboard, kitchen bench.