Power Connection - YORKVILLE YSS1 Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Plug the YSS's power cord into a grounded 20Volt, 60Hz outlet. Be sure the plug is inserted
all the way to avoid shocks.
Location
Although the YSS can provide substantial levels of sound pressure, should you require
more, low frequency sound pressure tends to increase somewhat with the source placed
close to a wall. For maximum emphasis position the YSS in a corner facing outward. Low
frequencies tend to be less directional than mids and highs hence you have considerable
flexibility when it comes to placement
Sources
Any audio source with *line-level outputs, whether it's a mixer, signal processor, tuner/ampli-
fier, CD, tape player, TV (with audio outputs), VCR or DVD player can be connected to the
YSS. The source's output can be balanced or unbalanced.
*(the YSS cannot accept speaker-level signals)
Connections
To connect the output of a stereo mixer or other audio source with RCA (phono) type outputs,
simply run a standard dual male RCA-to-dual male RCA cable to the A & B RCA Input connec-
tors on the YSS back panel. If your mixer only has a single (mono) RCA output you may use a
single-element cable of this type and simply connect it to either the A or B RCA inputs. This mono
capability applies to all the inputs. The YSS does not require a stereo input signal as the internal
amplifier is mono and stereo input signals are summed down to mono by the input circuitry.
XLR/¼-inch A&B "combi" Input jacks permit connecting a balanced or unbalanced line-level
output from the audio source. If the source outputs are ¼-inch unbalanced, simply run one or two
unbalanced ¼-inch-to-unbalanced (mono) ¼-inch cables to the YSS's combi inputs. If the source
output is balanced use either XLR (female) - to - XLR(male) balanced cables (e.g. low-impedance
mic cables) , or ¼-inch TRS (stereo) male-to-¼-inch TRS male balanced patch cords. Again, if the
source only has one output, just run one cable to either the A or B combi jack.
YSS1 ACTIVE STUDIO SUBWOOFER
The YSS is a self-powered active subwoofer designed
for accurate reproduction of the lower audio band down
to 32Hz. This, combined with a maximum sound-pressure
level of 9dB, provides basic performance that easily
responds to the demands of recordists in studio environ-
ments up to medium or large scale. Home theatre and
stereo system applications are also possible. A roster
of features adds flexibility at the professional level. All
three types of input connectors are included - balanced
XLR, balanced/unbalanced quarter inch and RCA, plus
straight-through balanced male XLR outputs so that you
may relay the source signals to powered full-range speak-
ers or a power amp. Controls regulate both volume and
low-pass frequency while a 2-way switch lets you invert
the YSS's phase. Thus all low-frequency sound param-
eters can be tailored to match the system/room response.

Power Connection

YSS1


Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ys1017

Table des Matières