Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. Initial settings
First push the
displayed and a long beep sound can be heard. Now release the
button and after 3 beeps release also the
is now in the initial setting mode. Display "No beep".
Use the
/% button to advance to the next menu item. Change
defaults with the
Once the complete initial settings have been set, push the 0SET
button to save and return to the surveying mode.
Below the individual steps in the menu:
Start with the
NO BEEP
No signal tone when horizontal angles 100, 200, 400 G are
scanned.
Factory setting: No BEEP
To activate the signal tone
Push the
button. Display:
To the next menu item
Angle unit: Change with
UNITA: 360°
UNITB: 400 G
UNITC: 6400 mil
Factory setting 360°
To the next menu item
Change vertical angle position
with
:
ZEN=0：
Zenith angle 0° or
ZEN=90：
Zenith angle 90°
Factory setting: 0°
button and then the
button.
and
buttons as outlined above.
/%.
:
/%.
button until all symbols are
90 BEEP
18
button. The device
Publicité
Table des Matières
