QEO FL 115H Mode D'emploi page 36

EN
RECEIVE A LASER BEAM
Power on the receiver and make all required settings (i. e. accuracy fine, sound high).
Carefully move the receiver up and down to detect the laser beam.
Indication 1
The laser beam is high
„arrow" is illuminated.
Acoustic signal:
Slow beep.
->Move the receiver up.
PLEASE NOTE:
If the distance between the rotating laser and the receiver is less than 1 m erroneous measurements
may occur.
APPLICATION
Connect the clamp to the receiver for use with a laser pole, levelling staff or similar accessory.
For optimum accuracy always level the bubble vials on the receiver before taking measurements.
36
Indication 2
The laser beam is low
„arrow" is illuminated.
Acoustic signal:
Fast beep.
->Move the receiver down.
Indication 3
The LED „0-position"
bar is illuminated.
Acoustic signal:
Continuous beep.
-> On level.