Fitting The Remote Control Panel - BROMIC RDV Série Notice De Mode D'emploi Et D'entretien

Mod.
Mod.
RDV1
RDV
RDV2
1
RDV
Electrical connection of evaporator: connect the evaporator using the wires supplied; pay attention to wire and
terminal board numbers. Close the connection box and fix the cable so that it does not interfere with fan
operation.
Close evaporator cover by repeating operations A) in reverse order.
Connection of refrigerating system: use the specially-supplied shut down valve connections on the condensing
unit and on the evaporator. With closed shut down valves put pipe fittings in vacuum conditions; then open the
cocks and start the unit.
Fit a drain line to the condensate water drain connection in the lower part of the evaporator.
6.6 Fitting the remote panel :
Remove the side screws and lift the front cover.
Fix the back plate to the wall using the pre-drilled holes; be careful the panel is kept in a vertical position.
Close the panel by remounting the cover. Fit the connecting cable between panel and unit making sure not to
bundle it with other cables.
A
A
508
928
26