Sigmar marine B0 20 UT Manuel De L'utilisateur page 15

POS. DESCRIPTION
1 Red plastic washer
2 Yellow plastic washer
3 Blue plastic washer
4 Relief/non return valve
5 Element gasket
6A Electric element
800W 220V
6B Electric element
800W 110V
6C Electric element
1200W 220V
6D Electric element
1200W 110V
7 Bi-Thermostat
8 Boiler resistor cover
9 Nut M4 stainless steel
10A Tank mounting
22 Lt
10B Tank mounting
20-30-40-60 Lt
11 Metal bracket
12 Screw M8 x 20 stainless steel
13 Screw M8 x 40 stainless steel
14 Washer Ø8
15 Nut M8 stainless steel
BOILER TERMOINOX 20/60 - REV001A
CODE
PVRPC300R000
PVRPM300G000
PVRPF300B000
MNVALS120000
• shut down power supply.
PGR031430000
• Remove the protection cover (8) in order to reach
EVR08220NSG0
the thermostat (7).
• Push on the reset button on the double thermostat
EVR08110NSG0
(fig. 3).
• Replace on the protection cover (8).
EVR12220NSG0
• Switch on power supply.
EVR12110NSG0
EVT101100000
PCCBRNP00000
MBD04MXEN000
MAINTENANCE
SLMMFS67TRX0
SLMMFS89TSX0
F
SLMMSTSP25P0
MBV0820MXE00
MBV0840MXE00
MBV08X000000
The overpressure release device must be activated regu-
MBD08MXEN000
larly to remove calcium deposits and to check that it is
not blocked.
Periodically check the joints of the water pipe instal-
lation; check the tightness of the securing screws and
replace them in case they are worn or corroded.
Also periodically check the safety of the electrical instal-
lation.
MAINTENANCE
WARNING: Sigmar Marine nautic water heaters
are provided with a double thermostat with man-
ual reset that shuts down power supply in case of
an excessive water temperature.
If it happens, follow the instructions below:
WARNING: if the high temperature safety works
repeatedly, call Sigmar Marine service center.
During wintertime, when the water heater is not
in use it should be drained using the lever of the
valve (4). This is to avoid serious damage caused
by freezing.
GB
15