Installation; Installation Site - Sigmar marine B0 20 UT Manuel De L'utilisateur

TERMOINOX WATER HEATER
Our long experience operating in the nautical field has given us the means to supply a new series of water
heaters with innovative characteristics compared with other avaible heaters.
The advantages, given by Sigmar Marine nautic boilers, are:
• high quality of materials ensure the product is both reliable and long lasting.
• Heat exchanger with a large exchanging surface.
• Producing hot water also by means of an electric element, which is provided with an adjustable
and safety thermostat.
• Relief/non return valve that allows discharging of water heater in case of disuse.
• The installation is easy and practical on a flat area.
BEFORE USING THE WATER HEATER READ CAREFULLY THIS INSTRUCTION MANUAL.
IF IN DOUBT, PLEASE CONTACT THE NEAREST "SIGMAR MARINE" DEALER.
WARNING: use this water heater in the applications described in this manual. Don't use the equip-
ment for any other purposes. Quick
personal injuries cause by a misusage of the equipment.
PAKAGE CONTAINS: water heater - user's manual - conditions of warranty.

INSTALLATION SITE

The water heater has to be placed in a dry and well-ventilated location. This precaution is required, even
though water heaters are made of sea environment resistant materials, since electrical systems are
present (in model provided with). Also if they are installed in environments that are not ventilated conden-
sation could occur. Condensation could be mistaken for a leak.
SET UP
• Put mounting (10) on the tank using studs and nuts provided (12, 13, 14, 15).
• Fix water heater on flat or inclined plane or wall, as shown in fig. 1, using proper mountings for the
weight of the water heater and for the type of installation site in the boat.
WARNING: the weight of water heater/unit in technical data refers to the empty unit. In order
to have the gross weight add to the empty weight, the water amount. (1 liter of water will almost
weigh 1 Kg. / 2,2 lb).
• Make hydraulic connections, relating to the input and output of tap water and from the engine
cooling to the heat exchanger, as shown in fig. 2. Make the connections as short as possible
between engine cooling system and heat exchanger.
WARNING: the overpressure release pipe must be positioned sloping evenly downwards in a loca-
tion protected from the formation of ice.
WARNING: water might drip from the overpressure release pipe of the device, and this pipe must
be left open to the atmosphere.
BOILER TERMOINOX 20/60 - REV001A
® will not be held responsible for damage to equipment and/or

INSTALLATION

GB
11