Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Shaft
Fig. 4
HOW TO USE
IMPORTANT: DO NOT attempt to operate the
appliance without the lid on.
1
Place pitcher on motor base and insert the blade
assembly. (See 'HOW TO ASSEMBLE'.)
2
Add the ingredients to the pitcher. Make sure
your total of ingredients don't go higher than the
highest measured marking line on the side of the
pitcher.
IMPORTANT: Never add ingredients into the
pitcher before placing the blades in first.
3
Place the lid onto the pitcher with the locking
handle in the upright position and the pouring
spout on the corner opposite the pitcher handle.
Align the arrows ( ) located on the lid and pitcher
handle. Ensure that the lid is completely seated
and press the lid down into the pitcher. Press the
locking handle down so that the latches on the lid
fit under the tabs on the pitcher. (Fig. 5)
NOTE: If you need to add additional ingredients
while the blender is processing, open the pouring
spout cap and pour the ingredients in through the
opening.
Locking Handle
Fig. 5
4
Plug the power cord into the electrical outlet and
press on the power button ( ).
NOTE: As a safety feature, the power button
( ) will flash and the motor will not work if the
pitcher and lid are not installed correctly. When
the pitcher and lid are installed properly, the power
button ( ) will be solid, indicating that the blender
is ready for use.
5
Select the speed according to your blending
requirements*:
• Use the LOW setting for processing and mixing.
• Use the MEDIUM setting for blending and ice
crushing.
• Use the HIGH setting for pureeing and
liquefying.
• Use the PULSE button for controlled chopping
and processing.
*
See Blending Chart.
www.ninjakitchen.com
13

Publicité

Table des Matières
loading

Table des Matières