Maxspect Jump SK Série Mode D'emploi page 8

You can adjust the foaming performance by following below guidlines.
EN
1. Water Outlet
2. Controller
Turn ON/OFF the Skimmer
Press the ON/OFF Button for about 5 seconds can turn on or off the skimmer. Each time when
the skimmer is connected to power, the system will count down from 10 seconds before it
starts to work.
Setting Working Speed
Press the Control Dial to enter speed-setting status, rotate the Control Dial to set a speed
among OFF/10/20.../100. Press again the Control Dial to save the setting.
Feeding
Press the Feeding Button can enter or exit the Feed Mode, the pump will stop working for 600
seconds(unchangable) and the Feeding Indicator will be strobing during the feeding period.
Over Flow Detection
The pump will stop working immediately when the buoy of the sensor is floating on the water,
the Over Flow Indicator will keep strobing. After the buoy is back to its normal position, it will
take 10 seconds waiting for the pump to start working again.
6
Rotate the knob to adjust the water outlet.
Speed/Time Indicator
Over Flow Indicator
ON/OFF Button
Operation Instructions
Control Dial
Feeding Indicator
Feeding Button