Perel CAMSET29 Mode D'emploi page 5

 Remove the adhesive foam.
Step 3
 Please note the UP sign at the
back of the camera.
 Turn the camera part upward.
 Gently slide the camera cable
through the hole and attach the
camera by pressing the adhesive
foam.
 Make sure the connector on the
wire is turned to the outside.
 Please note the UP sign at the
Step 4
back of the bracket.
 Slide the cable through the
bracket.
 Slide the screws from the large
part to the smaller part of the
slots.
 Tightly fix the screws and the
Step 5
bracket tightly.
 When finished, gently straighten
the camera cable.
 Open the battery lid.
Step 6
 Insert the Micro SD card as
shown.
 Install the batteries as shown.
Note: The device will only recognize
the SD card if inserted before the
batteries.
V. 02 – 27/11/2017
CAMSET29
5 ©Velleman nv