Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
terminal to another. Shorting the battery terminals
together may cause burns or a fire.
• Under abusive conditions, liquid may be eject-
ed from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid
contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause irritation
or burns.
specific safeTy rules
• Maintain labels and nameplates. These carry
important information. If unreadable or missing,
contact a MILWAUKEE service facility for a free
replacement.
Federal
Communications
Commission
this product may cause radio interference in which
case the user may be required to take adequate
measures.
This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when the equipment
is operated in a commercial environment. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is
likely to cause harmful interference in which case
the user will be required to correct the interference
at his own expense.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interfer-
ence, and
(2) this device must accept any interference re-
ceived, including interference that may cause
undesired operation.
specificaTions
Cat. No.
Volts
Memory Card
2311-20
12 DC
symbology
User must read operator's manual
Wear eye protection
To prevent electric shock, do not allow
product to contact live electrical parts
Federal Communications Commission
Direct Current
WARNING: This is a
class A product. In a
domestic environment
Interface Cable
SD
USB A/USB Mini B
funcTional descripTion
1. Camera
2. Camera LED
3. Cable
4. Socket sleeve
5. Memory card
slot/Interface port
6. Microphone
7. LCD
8. Power button
9. Picture Mode
10. Movie Mode
11. Playback Mode
12. Increase/Up button
13. Left Arrow button
14. Decrease/Down button
15. Select button
16. Right Arrow button
assembly
Warning
charger specified for the battery. For specific
charging instructions, read the operator's
manual supplied with your charger and
battery.
Inserting/Removing the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Connecting the Cable
1. Slide back the socket sleeve.
2. Line up the tab on the cable with the detent on
the socket.
3. Press the socket and cable together and slide the
sleeve over the connection. Tighten the sleeve
securely.
Fig. 1
1
Detent/Tab
4
3
5
4
6
1
2
10
11
9
8
12
13
14
Recharge only with the
2
3
7
16
15
Publicité
Table des Matières
