Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
EXCHANGING AND REMOVING DRILL
BITS
Before exchanging bits, first remove
the power plug from the wall socket.
Inspect bits regularly during use.
Blunt bits should be re-sharpened or
replaced.
When you want to use an SDS + drill, the
chuck needs to be open completely . Turn
the chuck key anti-clockwise until you hear
a click . Now you need to pull down the
release ring and insert the SDS + drill .
When not using the SDS + drill system you
are able to use conventional drills (wood,
metal, concrete) and bits by using the keyed
chuck .
SETTING DEPTH GAUGE
Fig . A
•
Loosen the handgrip by turning it
anticlockwise .
•
Insert the depth gauge ruler through the
hole in the auxiliary handgrip .
•
Slide the ruler to the desired depth .
Retighten the screw firmly.
FUNCTION SELECTION SWITCH
B
The correct position of the selection switch
for each machine function is given in the
diagram .
16
7062052_Rotary-Hammer_420W_Ma_#1408-11.indb 16
A: Drilling
B: Hammer Drilling
THE ON/OFF SWITCH
Fig . A
•
Switch the machine on by pressing the
triggerswitch (2) . When you release the
triggerswitch (2) the machine will turn
off.
Switch-lock
•
You can lock the On/Off switch by
pressing the triggerswitch (2) and then
pressing knob (4) . Release the switch-
lock by pressing the triggerswitch (2)
shortly .
Speed-control
•
The rotation-speed can be continuously
adjusted from 0 to 1500 and 0 to 6600
rotations per minute by pressing the
switch (2) deeper or less deep .
ADJUSTING OF THE MAXIMUM
ROTATION SPEED
•
Switch the machine on by pressing
triggerswitch (2) .
•
Lock the triggerswitch (2) by pressing
knob (4) .
•
Adjust the speed by turning the small
wheel (3) to the desired maximum rota-
tion speed .
SWITCHING THE DIRECTION OF
ROTATION
•
Direction of rotation counter-clockwise:
shift switch to "►" .
•
Direction of rotation clockwise: shift
switch to "◄" .
This function is only available when the
machine is set to "drill mode".
A
User tips
Always use the machine with the auxiliary
handgrip firmly anchored in place – you will
not only work with more comfort, you will
also work with more precision .
28-08-14 14:37
Publicité
Table des Matières
