Power Supply - i-tec USB 3.0 CHARGING HUB 4 PORT Mode D'emploi

EN Quick Start / USB 3.0 Charging HUB 4 Port
INSTALLATION ON WINDOWS, MACOS, LINUX, ANDROID, CHROMEOS
The hub is installed automatically from the system and doesn't require any
drivers. Connect the hub USB cable to an open USB port on your device.
DESCRIPTION
1. 1x integrated USB 3.0 cable for connecting to a device
2. 1x microUSB for connecting the hub secondary power supply with up
to 10 W (5 V/2 A)
3. 4x USB 3.0 port with quick charging support (BC 1.2)
4. 4x On/Off buttons for USB ports
5. 4x LED – indicates whether a port is turned on or off

POWER SUPPLY

When connecting devices with high power requirements (e.g. external
drives, mobile phones, etc.), it is important to use a microUSB power
adapter or to connect the hub via microUSB to an open USB port on your
device; adapter not included. Otherwise, the device USB port may not be
capable of supplying sufficient power to operate these devices.
CHARGING
The hub is capable of charging connected USB mobile devices such
as smartphones (including iPhone and Samsung phones), e-readers,
multimedia players, GPS, and tablets. The hub does not support iPad and
Samsung tablet charging that require special identification circuits. Simply
connect the device to the hub USB port using the original device cable.
Attention: All USB 3.0 ports support quick charging (BC 1.2), but only allow
charging a maximum of 1 mobile phone at a time.
To use quick charging, it is necessary to use a microUSB power adapter.
6