Wireless Remote-Controller; Battery Installation/Replacement; Outdoor Unit - Mitsubishi Electric Mr.SLIM PKA-A12HA Manuel D'utilisation

2. Parts Names

Wireless Remote-Controller

Remote controller display
* For explanation purposes, all of the items
that appear in the display are shown.
* All items are displayed when the Reset
button is pressed.
Set Temperature buttons
Fan Speed button (Changes fan speed)
Airfl ow button (Changes up/down airfl ow direction)
Mode button (Changes operation mode)
When using the wireless remote controller, point it towards the receiver on the indoor unit.
If the remote controller is operated within approximately 2 minutes after power is supplied
to the indoor unit, the indoor unit may beep twice as the unit is performing the initial auto-
matic check.
The indoor unit beeps to confi rm that the signal transmitted from the remote controller has
been received. Signals can be received up to approximately 7 meters in a direct line from
the indoor unit in an area 45° to the left and right of the unit. However, illumination such as
fl uorescent lights and strong light can affect the ability of the indoor unit to receive signals.
If the operation lamp near the receiver on the indoor unit is blinking, the unit needs to be
inspected. Consult your dealer for service.
Handle the remote controller carefully! Do not drop the remote controller or subject it to
strong shocks. In addition, do not get the remote controller wet or leave it in a location with
high humidity.
To avoid misplacing the remote controller, install the holder included with the remote con-
troller on a wall and be sure to always place the remote controller in the holder after use.

Outdoor unit

4
COOL
DRY
AUTO
FAN
HEAT
ON/OFF button
Check button
Test Run button
Service Panel
Transmission area
Transmission indicator
CHECK TEST
°F
RUN
MODEL
°C
Timer indicator
SELECT
STOP AMPM
FAN
SWING
START AMPM
NOT AVAILABLE
Operation areas
Timer Off button
Timer On button
Hour button
Minute button
Set Time button (Sets the time)
Louver button (Changes left/right airfl ow direction)
Reset button
1. Remove the top cover, insert 2 AAA batteries,
2. Press the Reset button.
Power
Ref. Pipes
Indoor-Outdoor
Connection wire
Earth

Battery installation/replacement

and then install the top cover.
1
2
3
Top cover
2 AAA batteries
Insert the negative (–)
end of each battery
first. Install the bat-
teries in the correct
directions (+, –)!
Press the Reset but-
ton with an object that
has a narrow end.