Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
If local codes permit, the hot water dispenser faucet tube should
be connected to ¹⁄₄" (6.4 mm) tube (not provided), which is
connected to the cold water supply line using a saddle valve (not
provided) or another means to connect the ¹⁄₄" (6.4 mm) tube to
the cold water supply line. If a saddle valve is used, do not use a
piercing type or ³⁄₁₆" (4.8 mm) saddle valve, which reduces water
flow and clogs more easily.
IMPORTANT:
■
If local codes do not permit the use of saddle valves, special
feed valves can be obtained from your local plumbing supply
distributor.
■
This hot water dispenser is shipped in one package.
■
Upon receipt of the hot water dispenser, inspect it for
possible shipping damage. Examine the hot water dispenser
inside the carton if the carton is damaged.
NOTE: The hot water dispenser is not a water purifier. Some
installations may require a water filtering system to improve the
quality of the water.
1. Determine the final location of the hot water dispenser faucet.
Check below the sink to verify that reinforcing ribs, support
brackets or cabinet construction will not interfere with the hot
water dispenser faucet.
2. To prepare the sink or countertop for installation, perform one
of the following:
■
Remove the plug from the sink.
■
Use an existing opening in the sink or countertop.
■
Cut a hole in the sink or countertop.
NOTE: It is recommended that only a licensed plumber or
professional installer should cut a hole in the sink or
countertop.
3. Straighten tube so that it will go through the hole in the sink
or countertop.
4. Remove the nut, metal washer and rubber washer from the
faucet.
NOTE: Do not remove the rubber O-ring in the bottom of the
faucet base.
Water Supply Requirements
INSTALLATION INSTRUCTIONS
Inspect Shipment
Install the Faucet
■
Connection to the hot water line is not recommended. Energy
will be wasted in heating the water twice and may produce an
undesirable taste.
■
A water filter is recommended if your water supply contains
sand, grit or other particles, or has a known taste or odor
issue. If a water filter system is used, the water pressure to
the hot water dispenser system from the filter needs to be a
minimum of 20 psi (138 kPa) for proper operation.
■
If the water pressure to the hot water dispenser system is less
than 20 psi (138 kPa), performance may be affected.
■
If damage is found, it should be noted on the carrier's freight
bill. Damage claims should be filed with the carrier
immediately. Claims of shortages should be filed with the
seller within 5 days.
NOTE: If any damages are discovered and reported to the carrier,
do not install the hot water dispenser, because your claim may be
denied.
A. Faucet base
B. Rubber O-ring
C. Rubber washer
5. Feed tube through the hole in the sink or countertop. Hold the
faucet in place while installing the rubber washer, metal
washer and nut on the faucet from underneath the sink.
Tighten the nut securely.
A
B
C
D
E
D. Metal washer
E. Nut
5
Publicité
Table des Matières
Dépannage
