POWER SMITH LASER PLTL320 Manuel D'utilisation page 6

OPERATION
UsING tHe LAseR LINe
NOTE:
Do not use the laser line on a surface other than
the one the tool is placed on. The line may not be accurate.
• For Horizontal Leveling Alignment: Activate the
Laser Line. With the Aluminum Surface of the tool at
the bottom, and the Laser Line Output (4) facing a
horizontal direction, level the tool by centering the air
bubble in Horizontal Bubble Vial (2) between the two
black lines. See figure 3.
• For Vertical or Plumb Alignment: Activate the Laser
Line. With the Aluminum Surface of the tool in a vertical
position, and the Laser Line Output (4) facing a vertical
direction, level the tool by centering the air bubble in
Vertical Bubble Vial (1) between the two black lines.
• For Angled Alignment: The tool can be aligned at any
angle, for example to hang pictures in a consistent line
going up a stairway. See figure 4.
UsING tHe LAseR poINteR (FIG 5)
The Mounting Base can be used on a flat surface or a
tripod to project a "Point" on a work surface. This Point
Function is useful when aligning wall outlets, hanging
hooks, and performing layout work at a consistent height.
1. Place the Base on a relatively level surface, or on a
tripod using the 1/4" threaded Tripod Mount (13).
2. Place the tool on the Base with the Magnets facing the
Point Metal Surface and the Aluminum Surface facing
Line Metal Surface.
3. Level the tool by using the Adjustment Screw (10).
4. Activate the Laser Point.
5. Rotate the upper part of the Base to the desired target.
NOTE:
If the level surface or the tripod does not extend
to the desired height, mark a reference point where the
laser point appears on the work surface and measure up
or down from that point to your desired height.
English
WARNING:
cleaning the lens. Serious injury to eyes could result.
• Keep the laser lens clean. A dirty lens will affect the
laser beam operation. Clean the lens with a moist
cotton swab. Clothes with nylon content could scratch
the lens causing the laser to operate incorrectly.
• Clean the tool housing with a moist cotton cloth.
Use only water. Do Not use cleaners, solvents or
compressed air to clean the tool.
• Never immerse or let liquid get inside the tool.
• Dry the tool with a cotton lint free cloth and allow to
dry completely before using or storing the tool.
This product is warranted free from defects in material
and workmanship for 2 (Two) years after date of
purchase. This limited warranty does not cover normal
wear and tear or damage from neglect or accident. The
original purchaser is covered by this warranty and it is
not transferable. Prior to returning your product to store
location of purchase, please call the Toll-Free Help Line
for possible solutions.
ACCESSORIES INCLUDED IN THIS KIT ARE NOT
COVERED BY THE 2 YEAR WARRANTY.
For questions about this or any other PowerSmith™
product,
Please call Toll-Free:
Or visit our website:
www.
powersmithproducts.com
6
MAINTENANCE
Do not turn the laser on while
wARRANTY
HELP LINE
888-552-8665.