Power-Saving Options; Customer Service; Troubleshooting - Medion AKOYA P54037 Mode D'emploi

8. Power-saving options

This monitor switches to different power-saving modes which are specified by the respective computer/operating sys-
tem. This complies with the current requirements for reducing the energy consumption.
The monitor supports the following types of power-saving modes:
Power consumption (nominal
Status
value)
ON > 20 watts (typ.)
READY < 0,5 watt
Depending on the operating system, the monitor remains in the power-saving mode until you press a key or move the
mouse (if available).
To switch from the READY state to the ON operating mode, the monitor needs roughly
2 seconds.

9. Customer service

9.1. Troubleshooting

If problems occur with your monitor, make sure that the monitor has been properly installed. If the problems persist,
then read this chapter for information about possible solutions.
9.1.1. Check cables and connections
Start by carefully checking all the cable connections. If the power indicator lights are not on, ensure that the monitor
and the computer are properly connected to the power supply.
9.1.2. Faults and possible causes
9.1.3. The monitor does not show a picture:
Check:
• Power supply: The mains cable must firmly inserted in the socket and the power switch must be switched on.
• Signal source: Please check if the signal source (computer or similar) is switched on and that the connection cables
are firmly inserted in the sockets.
• Refresh rates: The current refresh rate must be suitable for the monitor.
• Power-saving mode: Press any key or move the mouse to deactivate the mode.
• Screen saver: If the computer's screen saver is activated, press any key on the keyboard or move the mouse.
• Signal connector: If the pins are bent, contact your customer service.
• Set the applicable values for your monitor.
Colour of
operating light
blue
orange
Standby (approx.)
-
2 seconds
37 of 42
DE
EN
FR
IT
NL
DK