Topcom POWERLAN NS-6701 Guide D'installation Rapide page 8

PowerLan NS-6701
5 Connecting the Powerlan NS-6701 plugs
By default, the Powerlan NS-6701 plugs are not connected.
To connect them with each other, follow the procedure set out below.
1. Plug all the Powerlines into the power socket.
2. Push down the (reset/simple connect) key on the first Powerline plug
for two seconds.
The power-supply LED will flash slowly (0.5 seconds on/0.5 seconds off).
3. Within two minutes, push down the key on the second plug.
The connection sequence starts.
A random password will be exchanged between the Powerlines.
Once the connection is complete, restart both plugs and the
Powerline LEDs on both plugs will light up.
8
The Powerline plug switches to stand-by
mode (energy saving function) when it is
not connected to a device through an
Ethernet cable for 15 minutes.
The easiest way is to plug them in next to
each other in the same place. Once they
have been successfully connected, you can
put them in the desired location.
Push down the reset/simple connect key for at least
12 seconds to restore the Powerlan NS-6701 factory
settings. When the factory settings are restored, the
Powerlan NS-6701 plug will need to be reconnected!