How To Start - CGM SUPERPOWER 2200I Manuel D'utilisation

1. HOW TO START

◆ Only active outdoors. Generator of toxic carbon monoxide, a colorless, odorless gas that can
cause death or serious injury.
◆ To ensure that the generator is placed horizontally.
◆
Can not work in the rain, snow or other humid environments.
◆ Refuel away from cigarettes, sparks to avoid fire or explosion.
Checks before start
1. Remove the oil access door, unscrew the dipstick to check the oil. If oil level is below the
bottom of the dipstick, add the recommended oil (oil capacity: 0.4L). Use a strong detergency,
four-stroke engine oil and choose proper viscosity of the oil according to your area's average
temperature.
2. Unscrew the fuel tank cap to add gasoline to the fuel tank.
petrol or above 87 # gasoline. Not add too fast, so as not to spill gasoline. And to prevent dirt,
dust or water into the tank. Tighten the fuel tank cap after the addition was complete.
◆ Do not use two-stroke gasoline or dirty gasoline.
Start the generator
3. In the following way to start the generator.
B． Recoil start:
iv. Open the fuel switch.
v. Turn on the start switch.
vi. Gently pull the lever to start to feel resistance, then quickly pulled the handle to start,
start the generator.
4. When the
be used. Before connecting any load, the generator should be grounded. Please use a thick
cable to the ground terminal on the generator control panel is connected to an external
ground source.
5. Make sure all equipment and the switch are turned off and in order to ensure that
the equipment is
exceed the total power rating of the generator.
6. Connect your device to a suitable outlet generator control panel.
Be careful
output indicator lights
intact, confirm the
Warning
on the control panel, the
use of electrical
14
Please use unleaded
generator can
appliances does not