Switching On/Off - Goodyear 75544 Mode D'emploi

6.2 Switching on/off

26
75544-AZ-Schlagschrauber-GYD-IM-INT-OEF_191105.indd 26
1
This impact wrench is equipped with a rocker switch with which you can switch
from rotation to the right to rotation to the left.
• Put the mains plug (2) into a suitable mains socket.
• Select a suitable socket spanner. When attaching it, make sure that the socket
spanner sits fi rmly and securely on the socket spanner holder (5).
• Place the tool fi rmly on the fi xing element to be worked on (bolt or nut).
• For rotation to the right (clockwise, for tightening the fi xing element), push the
rocker switch to the rotation to the right position (F) (3). Before use, check that
the direction of rotation is correct.
The tightening torque is adjustable within a range between 100 Nm
and 350 Nm in steps of 10. If you press the - / + buttons you can
set the tightening torque to the desired level. The current torque is
shown on the large display located above.
This impact wrench is suitable for tightening and loosening bolts,
screws and nuts. Do not use it for any other purposes. Incorrect use
of this tool may cause personal injury or damage to property.
• For rotation to the left (anticlockwise, to loosen fi xing elements) push the
rocker switch to the rotation to the left position (R) (4). Before use, check that
the direction of rotation is correct.
• Release the rocker switch (3 or 4) to stop the tool.
• Pull the mains plug (2) out of the mains socket after you have fi nished working.
08.11.19 15:08