Perel WLC002 Mode D'emploi page 6

5. Installation
5.1 Mounting on Concrete
1. Choose an appropriate installation location:
Ensure that there are no electric lines, water or heating pipes installed at the proposed
o
drilling location.
The supplied wall plugs are only suitable for mounting on concrete and stone. Before starting
o
the installation, please check your installation location carefully for its suitability for the
plugs.
The recommended installation height is between 1 and 2 m above the ground.
o
The assembly material used must be suitable for the respective location. If in doubt, consult
o
a professional.
2. Mark the drill holes using the wall bracket.
3. Use a drill with a 6 mm drill bit to drill the required holes. Insert the wall plugs flush with the
wall.
4. Screw the wall bracket to the wall using the supplied screws.
5. Mount the camera on the tripod screw. Turn the camera in the desired direction and lock it with
the lock nut.
6. To align the camera into its final position, undo the two pivot bolts a little, align the camera and
fix the position by tightening the two pivot bolts.
5.2 Alternate Mounting
Use the included mounting belt to fix the camera around a tree trunk.
5.3 Powering
WARNING – Do not puncture batteries or throw them in fire as they may explode.
Do not attempt to recharge non-rechargeable batteries (alkaline). Dispose of
batteries in accordance with local regulations. Keep batteries away from children.
• Open the camera and remove the battery cover. Install the batteries following to the correct
polarity.
• If the camera is low on power, please connect the camera to a power adapter (not included, see
technical specifications).
V. 01 – 17/06/2020
WLC002
6 ©Velleman nv