Cooper Lighting Metalux DEL SN Instructions D'installation page 2

Installation Instructions – SN LED
INSTALLATION
SN LED
1. Remove product from packaging. Channel covers are
not fastened for installation purposes.
1. Wire according to code.
2. Install channel cover with screws provided (Figure 1.).
Row Aligner Instructions
1. Rotate end, pulling slightly the channel apart and
pushing the bottom of the end (Figure 2.).
3. Bend the row aligner and separate it from end
(Figure 3.).
4. Insert row aligner into channel. Insert wire holder if
running a harness along the row of fixtures (Figure 4.).
5. Add screws on the side of channels (Figure 4.).
6. Insert harness into wire holder if applicable (Figure 5.).
Endplate must remain in place at end of row.
N ote:
Figure 1.
1
1
Figure 2.
2
2
1
Figure 3.
Figure 4.
Figure 5.
Installation Instructions – SN LED
IB519098EN www.cooperlighting.com
Row Aligner
Wire Holder