Cooling System - Henry Schein HS-LED LIGHT 1200 Manuel D'utilisation

6
(B) START / STOP :
> Press once to begin or stop the curing cycle. At the last 3 seconds a "Beep" will sound
indicating that the cycle is almost finished.

COOLING SYSTEM :

The HS-LED is equipped with a special self-cooling system.
This completely shuts off the handpiece control panel to prevent overheating, after con-
secutively running 10 full curing cycles (of 30 seconds).
The machine should stay "off" for at least 6 minutes to allow complete cooling.
When repetitive curing process is required, please ensure the "time" for each curing
cycle is reduced.
The HS-LED is not suitable for the use in "Bleaching".