Panel Operations - Henry Schein HS-LED LIGHT 1200 Manuel D'utilisation

PANEL OPERATIONS :

(A) TIME (Power on) :
> Function 1 : Press the "TIME" button once to turn on the operation panel.
The digital display will show the curing time set from the previous working cycle.
> Function 2 : Hold down the button
until the numbers on the display
flash to reset the required curing
time. By pushing the "TIME" button
the time setting increases in
2 seconds increments. When the
required setting time is reached, press
the "START/STOP" button to confirm.
The maximum setting time is 30 sec
and then the display starts
again at 2 seconds.
IMPORTANT :
** This device will automatically switch "off " after being left at rest for 25 seconds.
Press the "TIME" button to turn the power back on again.
(B) (A)
5