Cleaning And Maintenance - Domo DO7326F Mode D'emploi

The higher the wattage, the faster the space will be heated.
In heating mode, the temperature can be adjusted using the temperature knob
be adjusted between 18 and 30 °C by pressing this button. The selected temperature is indicated by the
indicator light that illuminates (18 - 21 - 24 - 27 - 30). Once the desired temperature has been reached,
this indicator light will flash. The indicator light will alternately light up and flash because the appliance is
always trying to maintain the set temperature.
4. Turn the appliance off by pressing the on/off button again. After switching off, the appliance
continues to run for a while to cool down, this is normal and will stop after a few seconds. Once the
appliance has stopped running, unplug it.
SAFETY DEVICES
· This heater is protected with an overheat protection that switches off the heater automatically in case
of overheat, e.g. due to the total or partial obstruction of the grids. The overheating shut-off switches
off the temperature inside when the appliance exceeds the normal running temperature. The heating
element will automatically stop working, the motor will continue to operate, the internal heat shed.
This protective device applies only to the appliance itself and has no influence on room temperature
regulation. In this case, unplug the appliance, wait about 10 minutes for it to cool and remove the
object that is obstructing the grids. Then switch it back on as described above. The appliance should
operate normally. Should the problem persist, please contact the nearest customer service. When the
appliance turns on this safety feature, the fan indicator will light up and the low temperature indicator
light will flash.
· The appliance is also equipped with a tip-over safety, which is integrated in the appliance. The
appliance will turn off when it tips over.

CLEANING AND MAINTENANCE

· Before cleaning the appliance, ensure it is disconnected from the power supply and has cooled down
completely.
· To avoid the risk of electric shock, do not clean the heater with water and do not immerse it. Clean the
housing with a damp cloth.
· If necessary, dust particles accumulated in the air outlet openings may be removed with a vacuum
cleaner. This maintenance should be done regularly to assure the good operation of the appliance.
Dust particles in the appliance may cause over-heating.
· Allow the unit to cool down completely before storing it.
· Store the appliance in a clean and dry place.
· You can easily move the device thanks to the handles.
www.domo-elektro.be
. The temperature can
DO7326F
25