Beurer EM 28 Mode D'emploi page 25

Connecting the connection
cable and positioning the
wrist cuff
1. Connect the connection cable
with the metallic connection clips
on the wrist cuff.
Note
Before positioning the wrist cuff, first clean the body
parts to be treated.
Before positioning the wrist cuff, first moisten
the water contact electrodes and the wrist with
water.
Slip your arm into the cuff to position the cuff on your
wrist/lower arm. To position it more easily, please first
brace your arm against your upper body so that you have
a counter pressure and can then subsequently tighten
the cuff more easily.
For use on the right arm: If you have placed the cuff
on the right wrist/lower arm, please pull both straps
diagonally downwards.
For use on the left arm: If you have placed the cuff on
the left wrist/lower arm, please pull both straps diago-
nally upwards.
2. Fix the cuff in the desired position using the buckle
fasteners. Ensure that the cuff is not too tight but that
the water contact electrodes still have sufficient con-
tact with the skin.
3. Insert the plug for the connec-
tion cable into the connector
socket [5] on the control unit.
Replacing the battery
Please replace the batteries
when the battery status sym-
bol appears in the display [7].
• Open the battery compartment [4]
by pushing the cover in the area
marked with an arrow and sliding
downwards.
• 3 x 1.5 V batteries, type AAA (LR 03 Micro) should be
inserted for operation. Ensure the polarity is correct.
Observe the graphic in the battery compartment.
• Do not use rechargeable batteries.
25