Product Components; Using Your Cleaner - Candy VIVA Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
The Environment:
This appliance is marked according to the European directive 2011/65/EC on Waste Electrical and Electronic
Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise be caused by inappropriate
waste handling of this product. The symbol on the product indicates that this product may not be treated
as household waste. Instead it shall be handed over to the applicable collection point for the recycling of
electrical and electronic equipment. Disposal must be carried out in accordance with local environmental
regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product,
please contact your local city office, your household waste disposal service or the shop where you purchased the product.
This product complies with the European Directives 2014/35/EU, 2014/30/EU and 2011/65/EU.
CANDY HOOVER GROUP S.r.l. Via Privata Eden Fumagalli, 20861 Brugherio (MB) Italy

PRODUCT COMPONENTS

A. Wall Mount*
B. Turbo Button
C. Tube Release Button
D. Tube
E. Nozzle Release Button
F. Nozzle Front LED Lights
G. Brush Bar Release Assy
H. Floors Roller
I.
On/Off Button
J. Pre-Motor Filter
K. Single Cyclone Vortex Finder
L. Single Cyclone System
PREPARING YOUR CLEANER
1. Assemble the tube to the nozzle until you hear it "click" into place. [1a]
2. Assemble the main body unit to the tube until you hear it "click" into place. [1b]
3. Fully charge the battery by connecting the charger jack plug to the battery pack. [2a]
Charging time is approximately 5Hrs. It is possible also to charge the battery pack when released from the product. [2b]
The battery pack LED light will illuminate Red during charging and will turn White when fully charged. [3]
NOTE: To remove the nozzle press the nozzle release button and pull away from the main body.
NOTE: Use only the charger supplied with your cleaner to recharge.
IMPORTANT: When charging the cleaner must be switch off. You can charge the removable battery pack also when
released from the product.
It is normal for the charger to become warm to touch when charging.

USING YOUR CLEANER

• STANDARD MODE: When you press the switch On/Off, The cleaner is ready to clean thoroughly with the main
motorized nozzle. [4]
• TURBO MODE: Press the turbo button on the main body to fully power the product for hard cleaning tasks. [5]
• AUTO MODE: When the main motorized nozzle is removed, the product will automatically adapt to the lowest power
setting. [6]
If more power is needed, press the Turbo button on the main body in order to switch to the available power modes that
better suit your tasks.
* Certain Models Only
M. Dust Cup Flap Release Button
N. Dust Cup
O. Dust Cup Assembly Release Button
P. Battery Pack LED Light
Q. Battery Pack Charging Inlet
R. Battery Pack Release Buttons
S. Crevice Tool*
T. 2 in 1 Crevice and Dusting Tool*
U. Accessory Adaptor*
V. Long Flexible Crevice Tool*
W. Wall Mounts Screws*
3
GB

Publicité

Table des Matières
loading

Table des Matières