Air Compressor; Voltage Converter - VOLTCRAFT VC 900 A Mode D'emploi

11. AIR COMPRESSOR

open the cover of the storage compartment (20) in the rear. It contains the air hose for the air compressor. The includ-
ed adapters (24) can be used to charge not only vehicle tyres but also, e.g. soccer balls or similar.
Use the on/off switch (14) to switch the air compressor on or off. A manometer (1) is used for general air pressure
measurement, e.g of a tyre.
T he air compressor delivers air pressure of max. 18 bar. When filling, e.g. a tyre, observe the res-
pective correct value (observe operating instructions of the vehicle). There is a risk of explosion
and injury if the filling pressure is too high!
Never operate the air compressor unattended!
The operating time of the air compressor should not exceed 10 minutes. Otherwise, there is a
danger of overheating. Please switch the air compressor off after operation of approx. 10 minutes
and let it cool off entirely before continuing operation!

12. VOLTAGE CONVERTER

the reverse has an on/off switch (15) for operation of the voltage converter. An indicator light (22) shows the voltage
converter status. The 230 V socket (17) can be used to connect the corresponding consumers.
The maximum indicated permanent output of the voltage converter determines the maximum
possible power intake of the connected electrical devices (consumers). Before commissioning
observe that the maximum power intake of the consumers is not above the rated output current of
the voltage converter.
Some rechargeable devices can be connected to a socket with a separate charger. Certain other
rechargeable devices are equipped with an integrated charger. Such special devices may cause
damage inside the voltage converter and should not be used. The device temperature should be
monitored for the first 15 minutes of operation. If the device temperature rises unusually far, this
indicates that it cannot be operated with this voltage converter (e.g. power tools like cordless
screwdrivers). Most battery charging stations, however, will not cause any problems.
A fuse (16) serves to protect against overcurrent. It securely disconnects the voltage converter from the voltage source
if there is any overcurrent. Fuse replacement must only be performed by specialist trade or a qualified specialist.
You may operate the voltage converter with the motor off, as well as while the motor is running.
Never start the motor while the voltage converter is on. The cigarette lighter voltage supply is
interrupted during starting!
23