Elem Garden Technic MT60-139CC Traduction Des Instructions D'origine page 17

Allow the engine to cool before storing in any
enclosure.
Engine Maintenance
Please follow engine owner's manual to maintain
the engine.
Long Term Storage
If your cultivator will not be used for more than one
month, prepare it for long term storage.
Drain the gasoline in the fuel tank and carburettor.
Check oil. Remove the spark plug, add a little oil
into the cylinder, fit spark plug, rotate the crankshaft
and let oil be well-distributed in the inside surface of
the cylinder.
Pull the starter rope slowly until you feel
resistance, tie a knot to fix the rope, then close the
air valve to keep out the dust and other pollutants.
Remove all debris from cultivator tines and
engine.
Store cultivator in a clean and dry place.
Cleaning, maintenance
Remove the spark plugs for each
adjusting work and maintenance.
cleaning
_ Keep safety devices, slots
air to the crankcase and also clean (free
dust) as possible. Wipe the unit with
a clean cloth or blow it with the air
Low pressure.
_ We recommend cleaning the unit
directly after each use.
_ Clean the unit regularly with a
damp cloth and a little soap. do not use
any cleaning agents or solvents, they
may damage parts materials
plastics of the device. Ensure that no
water enters the interior of the device.
Maintenance
Warning: Stop the machine
immediately and
call made to your authorized
If vibration or unusual noises.
_ When the engine seems to be overloaded or This
misfire.
Maintenance of air filter
_ Check the air filter before each use, the
If necessary, replace it.
_ Open the cover screws of the air filter
and remove it.
_ Remove the filter cartridge.
_ To clean the element, do not use
corrosive cleaner or gasoline.
_ Clean the element by tapping on a surface
plane.
_ Installation is in the reverse order steps.
Maintenance of the spark plugs
Check the spark plug for the first time
after 10 hours. Locate
dirt and clean them if necessary to
using a brush son copper. Thereafter service the
spark plug every 50 hours.
_ Remove the spark plugs
On rotary movement.
_ Remove the spark plug with
spark plug wrench attached.
_ Installation is in the reverse order
steps.
Oil / oil level control
(before each use)
Change the engine oil must be when the engine is
at operating temperature.
_ Use only engine oil (10W30).
_ Remove the oil dipstick
_ Open the oil drain plug and pour the hot engine oil
in a container.
_ When the old oil has drained, close the oil drain
plug.
_ Fill engine oil to the mark Higher oil dipstick.
_ Be careful, do not screw the dipstick
Oil to check the oil level, but
insert it into the net only (H =maximum. / L = min.).
_ Must properly dispose of used oil.
GUARANTEE
Refer to the enclosed guarantee conditions
for the terms and conditions of guarantee.
distributor
17