Troubleshooting - Kicker 41KPWB Manuel D'utilisation

Troubleshooting

KPw is unresponsive or will not power on:
1. Check that the battery is fully charged by connecting the KPw to a known-good power source. Allow the
KPw to charge for at least 3.5 hours, then power on the speaker. The battery is full when the battery status
LED turns solid RED while charging.
2. Reset the KPw by pressing and holding the power button while inserting the USB charging cable. The
USB cable needs to be connected to a known-good power source.
KPw will not pair or connect:
1. If you have previously paired your device with the KPw, then please 'Unpair' or 'Forget this Device' per the
instructions for your audio device.
2. Press and hold the Bluetooth|Phone button for 5 seconds to enter pairing mode. Make sure your audio
device is scanning or in 'discovery mode', then select Kicker KPw.
Device paired and connected, but volume is low or inaudible:
Check the audio levels of both devices.
WARNING!
Keep out of reach of children. The content of this package includes small parts and cords that can cause choking or strangulation.
WARRANTY
KICKER products are warranted against defects. Duration and terms of warranty depend on the laws in the country in which it was
purchased. For details see your local KICKER Dealer or www.kicker.com/warranty.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a
replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a
major failure.
5