AEG FAVORIT 65712 M0P Notice D'utilisation page 28

28 www.aeg.com
• The deactivation of the rinse aid
dispenser when you want to use the
Multitab option without rinse aid.
• The level of rinse aid according to the
required dosage.
These settings will be saved until you
change them again.
How to set the programme
selection mode
The appliance is in programme selection
mode when the programme indicator
is on and the display shows the
programme duration.
When you activate the appliance, usually
it is in programme selection mode.
However, if this does not happen, you
can set the programme selection mode
in the following way:
Water hardness
German
degrees
(°dH)
47 -50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1) Factory setting.
2) Do not use salt at this level.
How to set the water softener
level
The appliance must be in programme
selection mode.
French mmol/l
degrees
(°fH)
84 - 90 8.4 - 9.0
76 - 83 7.6 - 8.3
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
<7 <0.7
Press and hold simultaneously Delay and
Option until the appliance is in
programme selection mode.
6.2 The water softener
The water softener removes minerals
from the water supply, which would have
a detrimental effect on the washing
results and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water
in your area. It is important to set the
right level of the water softener to assure
good washing results.
Clarke
degrees
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
1. To enter the user mode, press and
hold simultaneously Delay and
Option until the indicators
and
and the display is blank.
2. Press Program.
Water
softener level
10
9
8
7
6
1)
5
4
3
2
2)
1
,
start to flash